![]() I have 4 brand new installed lightsabers that need programming! Off to the races. 2 graflexes, one vintage, one 2.0 both with master chassis. ![]() Then I have a bunch of cool sabers to program. Hopefully I put the config on sd cards…I usually do. Now, I have to go back and try to re-author OS6 configs for my sabers. If they run zadig when the right driver is already installed, that messes things up. I think its also what is tripping up Windows11 users. EDIT: um no But it sure makes things a lot easier. Now Windows is truly better than MAC…just kidding BC. ![]() I’ll have a new video tutorial about how to set up a windows computer from scratch…this computer fiasco has been nuts. Um, I was also running screen recorder while I was setting up the computer so BAM. So, apparently Windows 11, at least the version I have, already has the appropriate driver set up. GREAT NEWS!!! After installing Arduino, Proffieboard Plugin, just for poops and giggles, I plugged in a proffieboard into my PC while Arduino was open, and what do you know? The port showed up!!! Never ran zadig. Today I began installing all the software needed to program proffieboards. I did my personal setup last night, which took awhile to recover what I could. Im guessing that it says (or should say) /dev/ttyACM0 or /dev/ttyUSB0. ![]() So, my Windows 10 computer crashed (failed hard drive). When youre in BF - check what it says to the left of the connect button.
0 Comments
Leave a Reply. |